升降貨梯以其操作簡便，能輕松實現貨物的上下運輸，省時省力等優點，被廣泛運用社會生產生活的方方面面。那么導軌式與剪叉式升降貨梯有哪些區別呢？

導軌式升降貨梯和剪叉式升降貨梯，從名稱上就看出兩者區別了，導軌式升降貨梯主要是以重型鏈條傳動，油絲繩做保險，設置的安全裝置要比剪叉式升降貨梯多得多，多重開關保護和斷電保護，讓導軌式升降貨梯的安全系數要比普通貨梯高上很多。導軌式升降貨梯適用于升降高度比較高的場所，在地坑方面 也不用挖很深的地坑，如果不能開挖地坑的地方也可以轉這款升降貨梯，例如在二樓裝液壓升降貨梯，不能開挖地坑，在平面上裝好之后，自身高度在100-300mm之間，如果往上拉搬運車的話，可以做個坡道，這樣既節省了地坑的難題和費用，也達到了客戶的需要。
Rail cargo lifter and scissor lift freight elevators, from the name to see the difference between the two, and rail cargo lifter mainly heavy chain drive, oil rope for insurance, provided safety devices than scissor lift freight much more multi-switch protection and power protection, so that rail cargo lift safety factor higher than the average freight on a lot. Rail cargo lifter applies to the height of a relatively high place in the pit also do not dig deep pit, if not the excavation pit where you can also turn this cargo lifter, for example, on the second floor mounted hydraulic lift freight elevator not excavated pit, after a good flat tops, their height between 100-300mm, if the van pull up, you can make a ramp, thus saving pit problems and costs, also reached customer needs.

剪叉式升降貨梯上升平穩，結構比較牢靠，故障出現率較低，導軌式的上升高度要比剪叉式的高出很多，維護量比剪叉式的少，但是客戶在選擇上面要根據現場實際情況來選擇。剪叉式升降貨梯是屬于多叉式組合而成的升降機，一般來說自身高度比較高，而且在升降高度方面，升降幅度太高的場所不適合做剪叉式升降貨梯，從而證明了剪叉式升降貨梯在貨裝卸小車的話需要跟地面是平的，就要下挖很深的地坑，這樣安裝好之后太能跟地面是平的。
Scissor lift freight rose steadily, the structure is solid, low failure rate, increased rail height higher than the Scissor much maintenance is less than scissors, but customers in the selection according to the above site The actual situation to choose. Scissor lift freight belongs to multi-fork-lift combination, in general, their height is relatively high, but also in terms of lifting height, lifting magnitude too high places is not suitable for scissor lift freight elevators, thus proving Scissor cargo loading and unloading cargo lifter in the car if needed with the ground is flat, we must dig deep pit, then so too sorted installed ground is flat.